|
1.
|
|
|
In the next steps we will configure your router in such a way that the router allows Zultrax P2P to accept incoming connections. For this we need first to look up the port number used by Zultrax P2P. By default this port number is set to 6346 but it could be that you changed this number.
Zultrax P2P can help you to find the port number. In the menu tools choose system info. This will display a page of information with various details about the program amonst which port. Write the given number for port down, you'll need it later.
|
|
|
|
|
2.
|
|
Exit Zultrax P2P. Don't leave the program running while you are performing the actions below. Leaving the program running might give you false indiciations that your actions where not succesfull.
|
|
|
|
3.
|
|
Open a webbrowser (e.g. Internet Explorer, Firefox or Opera). Enter the IP address of your router in the address bar of the browser and press enter. The IP address of your router is by default 10.0.0.3
|
|
|
4.
|
|
You see a box asking your username and password. By default the username for your Zoom X5 router is admin and the password is zoomadsl
Enter your username and password and click the ok button to continue.
|
|
|
5.
|
|
Click the button advanced setup.
You find this button on the top of the page.
|
|
|
6.
|
|
Click the button nat.
You find this button on the center of the page.
|
|
|
7.
|
|
In the drop down box nat option select the value nat rule entry
|
|
|
8.
|
|
Click the button add.
You find this button on the bottom of the page.
|
|
|
|
10.
|
|
Click the button advanced setup.
You find this button on the top of the page.
|
|
|
11.
|
|
Click the button ip filter.
You find this button on the center of the page.
|
|
|
12.
|
|
In the drop down box security level select the value none
|
|
|
|
14.
|
|
|
|
Your Zoom X5 router is configured now. You forwarded a port for Zultrax P2P. You can start Zultrax P2P and you will see incoming connections coming up. This might be not immediatly after start up but within minutes you should see at least some incoming connections. The program will adapt itself to the new configuration.
In case you still don't have incoming connections, perhaps you also have firewall software installed that needs configuration. For that see
the Firewalls/Routers page
, the info about firewall software is somewhere at the bottom of that page.
|
|
|
|
